In procedure 'reset' called at file "embedded:startup.tcl", line 478ģ. Warn : STM32 flash size failed, probe inaccurate - assuming 128k flashĢ. Info : accepting 'gdb' connection on tcp/3333Įrror: timed out while waiting for target halted Info : stm32f1x.cpu: hardware has 6 breakpoints, 4 watchpoints Info : STLINK v2 JTAG v17 API v2 SWIM v4 VID 0x0483 PID 0x3748 Info : Unable to match requested speed 1000 kHz, using 950 kHz Srst_only separate srst_nogate srst_open_drain connect_assert_srst The results might differ compared to plain JTAG/SWD Info : The selected transport took over low-level target control. console (openocd) output when “debug” was started When initial created by “System Workbench for STM32” using the instructionsĪfter my modifications it runs at least on the command line (3)ġ. # use hardware reset, connect under reset
# Generated by System Workbench for STM32 # This is an STM32F103C8T6-mini board with a single STM32F103C8Tx chip. The config file for Openocd currently is: When I use Target -> Program Chip in the Project Explorers context menu nothing at all happens. When I try to debug or just click on “run” Openocd throws errors (1)(2) The project includes freeRTOS and builds without errors. I have installed “System Workbench for STM32” and its tools in eclipse now and have used a stand alone CubeMX for creating a project. I can upload sketches in the Arduino_STM32 environment with this thing. I’m trying to setup a project for a little dev board
0 kommentar(er)
